@balique_bap wrote:
Hi,
I try to model a solar plant on a particular location.
Here is my situation :
- i have a first layer with many ( >5000) identical components (solar panel structures), placed on an horizontal plane. Their position has been set before. (I designed it according to a 2D map of the site)
- I have a layer with the topographic lines of the site where I want to place the plant. These lines are in 3D. I created surfaces from it thanks to the tools "From Contours" in Sandbox.I would like to move each of my components to fit the topographic surfaces. It is easy for one particular component : I select a bottom corner, I force a vertical (blue) move and put my cursor to the corresponding surface. If I want to make it perfect, I need to rotate it to fit the angle of the surface.
So it is easy for one component but I have thousands of them.
My question is : is there a way to make it automatic ? I would select all my components, then select the "**Magic***" tool, select the layer with the surfaces, and that would be done.
Thank you very much for your help !
Posts: 7
Participants: 3