@arhude wrote:
I want to do something very simple but can't figure it out. I use Push/pull all the time but it doesn't work in this case. Let's say I make a 2x4 piece of wood. If it has a square-cut end, I can extrude that to make the board longer or shorter. But if it has an angle-cut end, I can not lengthen or shorten that 2x4. Push/pull extrudes the angled face perpendicular to the face, not along the length of the board. Follow me doesn't work either because the face has to be perpendicular to the path. I would think this would be something simple and I need to use it all the time but haven't been able to.
Posts: 8
Participants: 3