@NewThinking2 wrote:
External Elevator Track and Lattice.skp (455.1 KB)
I am (still) trying to continue a track - actually 2, one in each inside corner - of a supporting structure that follows an arc 180 degrees. It is a half circle. But copying the track segments for my cog elevator/tram is both tedious and produces unsatisfactory results when I try to curve it all the way around.
I need 4 tracks, one in each corner, with two pairs facing each other as shown in the attached .skp file.
Follow me does not work for a 3D component...or does it?
Perhaps I need to step back and construct a single component and continue THAT all the way around the arc?
Posts: 11
Participants: 2