@rabbithutch wrote:
Elliptical Fanlight.skp (156.8 KB)
I have 2 questions about the attached drawing.
First, in order to define a plane that I can fill with transparency, I need to connect the areas between the fanlight dividers. I don't know what tool to use - and obviously how to use it - to draw the connecting lines at the hub and on the arch on either of the spokes.
Second, I need to make the outer arch an inch thick without expanding the radius. The pull down tool does not do curved surfaces. What tool should I use and how do I use it?
Can anyone advise me here? Are there tutorials I should read/watch?
Posts: 4
Participants: 3