@Rick wrote:
I'm not sure what to do about getting this "Don't Panic your model is messed up" Error.
I have one clean solid component (The large heart), and one clean solid group of 3d text that I used the Subtraction Solid Tool to engrave the larger component.... and even though I run CleanUp3 and I run Solid Inspector2 on every component to make sure it's clean and solid.... I keep getting this error message when I try to save. My models are blown up 1000 times large and I run all of the clean up and solid inspector tools before and after I merge or subtract anything.
I'm not sure what to do from here because all of my models are intended to be 3d printable so I'm not sure if I can ignore this error.
Looking at the newly "engraved" text... it appears fine and the component says it's solid when running inspector tools. But if I try to save the model, or fix it running clean up.... it wants to close some of the numbers.
I would greatly appreciate any advice. I've attached the model since I don't create commercial jewelry, only projects for friends or family.final double hearts project.skp (853.0 KB)
Posts: 9
Participants: 3