@Yusunoha wrote:
hello everyone, I'm having a small problem with sketchup that I've started using recently.
the problem I'm having is with the push/pull tool.
I'm trying to make a shape smaller by using the push/pull tool going inwards on a surface. with the tool this works as expected, but I'm trying to use precise measurements so I enter the value that I want the surface to go inwards, which in this case would be 5mm. so I enter -5 (as I'm using millimeters as measurement) but instead of going inwards the surface goes outwards, just as if I had entered a positive value.I don't know what I'm doing wrong, but I am probably doing something wrong and I was hoping someone could tell me what I'm doing wrong
Posts: 6
Participants: 4